Pictures

New dust collector, hand-build and assembled:

Wide shot of LL Guitars shop/storage:

Construction in the LL Studio

I have been working on my shop for the last month or two. I installed the 2 HP cyclone dust collector in the small room behind the garage. That took a week or more, since I only work about 2 hours in the 90 degree heat. I limited myself to installing one section a day. Before that, I insulated the walls and put up drywall in the small room. Sloooooow process.

After I got the main parts of the dust collector up, I hoisted the motor/fan up with a block and tackle and eased it into position. Then I re-installed all the parts I had taken off the motor/fan to lighten it. I have a piece of an old undershirt that I use for a sweatband, and I look like an old hippie in my cut off shorts and holey tee shirt and sweat band.

But wait! There's more! My next step was to make a stand for the exhaust filter, which is about 5' high and about 14" in diameter. After that, I installed the 5" ducting from the fan to the filter. Then I started the 6" trunk line that runs the length of the shop to the collector intake. Three 90 degree els, one 45 degree el, two 4" y's off the main, and about 16' of the 6" spiral seam pipe. Then I screwed or riveted the joints together, and ductaped the joints to make them air-tight. Now I sound like a plumber, right?

I have finished the 4" down tube and blast gate for the duplicating router. You can see the duplicating router on the blog. I still have to install down tubes for the thickness sander, the bandsaw, and the table saw. After the main trunk, the electricians came in and wired up the dust collector and the additional outlets needed. This last week I tore out part of the partition between the small room and the shop area, so that I don't have to use the overhead door all of the time. Yesterday I sized the panels for three 4' long wall cabinets. I will install them after I insulate and sheetrock the walls. I am hoping to finish it all before the colder weather, so I can spend the winter working on GUITARS, insted of construction.

I have enough Mahogany for at least six backs/sides, left over from furniture days. I also have a beautiful piece of Wenge, a very dark tropical hardwood. I plan to use it for the back and sides of an archtop. I only have six Spruce archtop sets, but I should have plenty to keep me busy if I get the shop squared away.

.............................................

This blog and its contents are property of luthier Paul Lloret of LL Guitars (pronounced “Double L Guitars”). For more information on Paul Lloret and his guitars, contact LL Guitars.